Skip to content
WA Lic. THERMIL757RN · Licensed, bonded & insured Mon–Fri 8–5 · We answer our own phone

Check Your Attic Insulation Before Winter in Spokane

Get a free estimate

Usually back to you within the hour. Or call (509) 200-7677.

Goes straight to our phones and email. We don’t sell it or put you on a marketing list. Privacy policy

October is the easy time to look at your attic. Before the first hard freeze, check how deep the insulation is and what shape it is in. If it is thin, matted or damp, your furnace works harder and some rooms never warm up.

In a Spokane winter, warm air rises and leaves through the roof. The attic insulation is what slows that down. When the layer is thin, flattened or settled, more heat escapes and the house feels it. Here is a quick look you can do yourself, and what to do with what you find.

How to check your attic

Stay on the attic hatch ladder or on boards that are laid across the joists. Do not step between the joists. The ceiling below is not made to hold your weight.

From there, look at three things:

  • Depth. Can you see the tops of the ceiling joists? If so, the layer may be too shallow. A deeper layer covers the joists completely.
  • Shape. Is the insulation matted down, uneven, or pushed aside in places? Gaps near the eaves and around the hatch are common.
  • Condition. Is it damp or dirty? Do you see droppings, nesting material or stains from a roof leak?

You do not need a tape measure to get a first answer. If you can see wood where you should see insulation, it is worth a closer look.

When a top-up is enough

If the old insulation is clean and dry and has simply thinned out or settled, new material can often go on top. We blow loose fiberglass into attics until they reach R-60, and we seal gaps first. On older houses where the attic cannot fit R-60, usually on replacements, we insulate to R-49. Air sealing matters because warm air that leaks around wiring, pipes and the hatch bypasses the insulation. Adding more on top of leaks only fixes half of the problem.

If that is your situation, we will tell you it is a top-up, and quote you the smaller job. You can read more about blown-in insulation and how an attic job goes.

When the old insulation has to come out first

Some insulation should not stay. If it has been wet, been through smoke, or had mice or rats in it, putting new material on top buries the problem. Insulation is fiber, and it holds on to moisture and waste. That job starts with taking the old material out.

See our page on attic insulation removal and replacement for how that works.

Why October

Once the cold arrives, an attic job gets less pleasant for everyone. Checking now means you can decide with time to spare, instead of in a cold snap with a high heating bill. It also gives you a chance to find a small leak or gap before winter weather makes it worse.

Not sure what you are looking at?

Photos are fine. Send a few pictures of the attic, or ask for a free on-site estimate. We serve Spokane, Spokane Valley and North Idaho. We will look at the depth, the condition and the air leaks, and tell you which of the two jobs your attic needs.

Ask for a free estimate or call (509) 200-7677. THERMIL757RN.

Stop heating the sky.

Free on-site estimate, usually within a day or two.

Mon–Fri 8–5 · we pick up (509) 200-7677
Estimate Call